Swage Studs with Lag Screw

Bridco stainless steel Swage Studs with Lag Screw are available in 2 sizes (see table below).
We supply high quality grade 316 stainless steel lag screw swage stud terminals, left and right hand threaded. Terminals must be properly swaged with a swaging machine. Commonly used in balustrade applications.

Specifications – Swage Studs with Lag Screw

  • Material: AISI 316 Stainless Steel
  • Production: Forged where F present in code, Cast otherwise
  • Surface Finish: Electro Polish
  • B.L: Nominal Breaking Load

Find Swage Studs with Lag Screw on page 34 of the Bridco Catalogue (PDF).

Category:

The following chart is a guide to terminal sizing.
All care possible is taken to ensure measurements are accurate at all times.
However, slight size changes may occur from time to time, so please ask us to confirm particular sizes if your dimensions are critical.

CODEA
mm
D
mm
L
mm
L1
mm
L2
mm
SS-7831R-061/8″6mm Right904040
SS-7831L-061/8″6mm Left904040

R = Right hand thread, L = Left hand thread.
Bridco swage lag screws use left hand thread one end and right hand the other, tension is gained while screwing in.

Number of Sizes

2

Page number in Catalogue

34

Material

Grade 316 Stainless Steel

Name
Email
Phone
Enquiry