Stainless Steel Height Safety Fittings - Australia


Height Safety Rigging screws and fork terminals to suit 8mm (5/16”) wire rope.

Links below to go to a 2 page PDF (2.2MB) which has more information including the range of different sizes and exact dimensions for each stainless steel height safety fitting listed below.


Bottlescrew Jaw and swage stud Fork terminal Bridco Bottlescrew jaw swageless Bridco Stainless Steel Bottlescrew Fork Terminal
Bottlescrew
Jaw and swage stud
Stainless steel

Also see in pdf icon
Fork terminal
Grade 316
Stainless steel

Also see in pdf icon
Bridco Bottlescrew Jaw
Swageless Grade 316
Stainless steel

Also see in pdf icon
Bridco Swageless Fork
Terminal Grade 316
Stainless steel

Also see in pdf icon
Stainless steel swageless terminal      
Swageless Terminal
Grade 316
Stainless steel

Also see in pdf icon
     


HOW TO USE BRIDCO (SWAGELESS) SWAGES
For use with 8mm 7x7, 7x19 or 1x19 construction.

Diagrams still to be inserted.
Step 1. Feed wire through cone and spread 3 piece clamp around wire, leaving 5mm of excess.

Step 2. Push 3 piece clamp into cone and slide the ring over the excess wire. Screw the head on firmly with spanners to hold assembly together.

Step 3. Screw lock nut to secure assembly.

Step 4. Repeat process for threaded part in Bottlescrew

Notes: To determine the length to cut the wire, first measure the bearing point to bearing point dimension, this will be the distance between the 2 fixings on the posts shown above.

Bearing point to bearing point measurement (-) 215mm = Wire cut length.
Measurements are with bottlescrew in half open position.

Load capacity outweighs wire breaking strengths provided the setup is assembled correctly. Fittings suitable for balustrade only, not suitable for yacht rigging.
No responsibility is taken for misuse or poorly assembled systems.